– 47 –
The movement of the cam has also closed lock
switch 2 which signals the control that the door is
locked. The control then removes power from the
lock motor circuit by de-energizing the lock relay.
The lock motor stops and lock switch 2 is held
closed by the cam through the clean cycle.
The word
LOCKED
stops flashing and remains
illuminated in the display.
The word
ON
remains
illuminated in the display.
During the Clean Cycle the oven will cycle to
maintain an average clean temperature of 815°F
(435°C).
Clean Cycle and Lock Sequence:
Program the Clean Cycle:
Press
SELF-CLEAN
pad. 4 hours and 20
minutes (4:20)‚ appears on the time display.
(Cleaning time can be changed from the 4-
hour 20 minute starting point by pressing the
SELF-CLEAN
pad a second time.)
After
START
has been pressed, the word
ON
illuminates in red and the word LOCKED
flashes to indicate the cycle has begun.
Locking the Door:
After programming the clean cycle and
pressing
START
pad, the control energizes
the lock relay. Voltage (120 VAC) is applied
to the lock motor circuit. Oven door must be
closed before lock motor can run.
LOCKED
will flash and control will beep until the door is
closed.
The lock motor begins to revolve and turns a
cam mounted to the motor shaft.
The word
LOCKED
will flash on and off on
the display while the lock motor is in motion.
As the cam revolves about
1
/
2
revolution
(approximately 12 seconds), it has moved
the lock hook into a corresponding slot in the
oven door which secures the door.
The words
LOCKED
and
ON
with the clean cycle
time remaining will be displayed.
1.
•
•
2.
•
•
•
•
Door Unlocked
Door Locked
