– 36 –
IMPORTANT:
When reinstalling the oven
temperature sensor, the connector end must
be positioned
OUTSIDE
the range insulation.
Insulation should be allowed to close in around
the oven temperature sensor lead wires thus
protecting the sensor from any heat loss at the
insulation opening.
Note:
When reinstalling the sensor, use a small
flat-blade screwdriver to push and guide the
sensor wire harness into the oven liner.
11/16-in.
9/16-in.
Gently pull the sensor wire harness into the
oven.
6.
Safety Valve and Pressure Regulator
WARNING:
Before servicing the range, power
and gas must be removed from the range. Make
sure the oven is completely cool.
Note:
The safety valve and pressure regulator
are a "combi-valve" and are removed and
replaced as an assembly.
The combi-valve is front serviceable. The
amperage should be between 3.3 to 3.6 amps at
3.0 to 3.3 VAC.
To replace the combi-valve:
1. Remove the oven door (See
Oven Door.
)
2. Remove the warming drawer (See
Warming
Drawer.
)
3. Remove the bake burner (See
Bake burner
and Glow-bar Igniter.
)
4. Remove the gas line connections indicated
below, note the wiring locations, and
disconnect the wiring.
5. Remove the hex-head screws that hold the
combi-valve in place.
6. Remove the combi-valve.
