LG GDL1329CED3, Service Manual

Page: 32 / 79

32
Remove the terminal block access cover on the
upper back of the dryer. Install a UL-listed strain
relief into the power cord through-hole; then
thread a UL-listed, 30A, 240V, 3-wire, #10 AWG-
minimum copper conductor power cord through
the strain relief.
2
1
Attach the two hot leads of the power cord to the
outer terminal block screws. Attach the neutral wire
to the center terminal block screw. Connect the
external ground (if required by local codes) to the
green ground screw. TIGHTEN ALL SCREWS SECURELY.
Reinstall the terminal block access cover.
construction after January 1, 1996. with #10 AWG-minimum copper conductor
and closed loop or forked terminals with
upturned ends.
G round Sc rew
UL-Listed
Strain Relief
UL-Listed
3-Wi re
Power Co rd
Terminal
Block
G round Wire
Hot
(Black)
Hot
(Red)
Neutral
(White)
WARNING:
Connect the power cord to the terminal block. Each colored wire should be connected to same color
screw. Wire color indicated on manual is connected to the same color screw in block. Failure to follow
these instructions may result in a short or overload.
Grounding through the neutral conductor is prohibited for: (1) new branch-circuit installations,
(2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through
the neutral conductor.
!