LG GDL1329CED3, Service Manual

Page: 33 / 79

33
Remove inches (8.9cm) of the outer covering
from the wire. Strip 1 inch (2.5cm) insulation from
each wire. Bend the ends of the three wires into a
hook shape.
2
1
Attach the two hot leads of the power cord to the
outer terminal block screws. Attach the neutral wire
to the center terminal block screw. Connect the
external ground (If required by local codes) to the
green ground screw. TIGHTEN ALL SCREWS SEVURELY.
Reinstall the terminal block access cover.
3
G round Sc rew
Neutral
(White)
Hot
(Black)
G round Wire
Hot
(Red)
Remove the terminal block access cover on the
upper back of the dryer. Install a UL-listed strain
relief into the power cord through-hole; then
thread the power cable prepared in Step 1 through
the strain relief.
2
UL-Listed
Strain Relief
UL-Listed
3-Wi re
Power Co rd
Terminal
Block
1" (2.5 cm)
construction after January 1, 1996. conductor cable.
removal and reinstallation of the dryer.
WARNING:
Connect the power cord to the terminal block. Each colored wire should be connected to same color
screw. Wire color indicated on manual is connected to the same color screw in block. Failure to follow
these instructions may result in a short or overload.
Grounding through the neutral conductor is prohibited for: (1) new branch-circuit instrallations,
(2) mobile homes, (3) recreational vehicles and (4) areas where local codes prohibit grounding
through the neutral conductor.
!
3
1