28
Optional Operation
Installer Setting -Thermistor
This function is to select a temperature sensor to determine the indoor temperature.
Press and hold
B
button for more than 3 seconds to enter the installer settings mode.
- If pressing only once briefly, it will enter the user settings mode.
Make sure to press and hold for more than 3 seconds.
Move to the Selection of Indoor Temperature Sensor (Thermistor) in the
menu using
B
button and then, it displays as below.
Select the location of indoor temperature
sensor (Thermistor) using
F G
button.
Press
K
button to save the setting.
Press
L
button to exit.
h
If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
h
If the
K
button is not selected before you exit, the changes will not apply.
Code value for
Room temperature sensor
(Thermistor)
Set value
❈
Set value for sensor location
01 : Remote control
02 : Indoor unit
03 : 2TH
Temperature sensor
selection location
Function
01
Remote control
Operating by a temperature sensor in Remote controller
02
Indoor unit
Operating by a temperature sensor in the indoor unit
03
2TH
Cooling
Operating at a higher temperature after comparing the temperatures between indoor
unit and cable remote control
(Some product may operate at a lower temperature.)
Heating
Operating at a lower temperature after comparing the temperatures between indoor
unit and cable remote control
h
2TH functions/features vary according to the product.
1,MFL67939921,영영 2018. 8. 2. 영영 1:41 Page 28
