Remote Controller Installation
Installation Manual
23
ENGLISH
Remote Controller Installation
1
2
3
2
3
<Wire guide grooves>
1. Please fix tightly using provided screw after placing
remote controller setup board on the place where you
like to setup.
- Please set it up not to bend because poor setup could take
place if setup board bends.
Please set up remote controller board fit to the reclamation
box if there is a reclamation box.
- Install the product so as not to make a gap with the wall
side and to prevent shaking after the installation.
2. Can set up Wired remote controller cable into three
directions.
- Setup direction: the surface of wall reclamation, upper, right
- If setting up remote controller cable into upper
and right side, please set up after removing
remote controller cable guide groove.
h
Remove guide groove with long nose.
①
Reclamation to the surface of the wall
②
Upper part guide groove
③
Right part guide groove
3. Please fix remote controller upper part into the setup
board attached to the surface of the wall, as the picture
below, and then, connect with setup board by pressing
lower part.
- Please connect not to make a gap at the remote controller
and setup board’s upper and lower, right and left part.
- Before assembly with the installation board, arrange the
Cable not to interfere with circuit parts.
When separating remote controller from setup board, as
the picture below, after inserting into the lower separat-
ing hole using screw driver and then, spinning clock-
wise, remote controller is separated.
- There are two separating holes. Please individually sepa-
rate one at a time.
- Please be careful not to damage the inside
components when separating.
Wall
Side
Wall
Side
Wall
Side
Wall
Side
<Connecting order>
<Separating order>
1,MFL67939921,영영 2018. 8. 2. 영영 1:41 Page 23
