Installation and Operation Manual
54
4
4
U
U
S
S
E
E
F
F
U
U
L
L
I
I
N
N
F
F
O
O
R
R
M
M
A
A
T
T
I
I
O
O
N
N
4.1 Trouble shooting
If you experience any problems with the normal use of your phone, you should first power-off and
disconnect the battery. Then connect it again, and connect the power again. If the phone continues to have
problems, please check the following Table before contacting the Customer Service center.
PROBLEM
POSSIBLE CAUSE
SOLUTION
There is no dial
tone
• Is the telephone line cord
correctly plugged into the
base and telephone
socket?
• Is the Terminal registered
to the base?
• Check that the base is connected to the main power
source and the battery is properly installed.
• If you try to make a call and the terminal is not
registered, the display shows
„Out of Range‟.
Cannot make or
receive calls
• Are the Handset batteries
charged?
• If the battery symbol shows empty then replace the
handset on the charger and let it charge for a few
hours.
Terminal does
not ring
• Have you set the terminal
ringer volume to Volume
Off?
• You can set the ringer volume for LWS-BS,
Wireless Keyset and Handset. Verify if the ringer
volume is set too low for you, and adjust if
necessary.
Cannot link up
with the LWS-BS
station
•
Is “Range Out” display?
• The LWS-BS power cable may not be connected.
The AC power has failed and/or the batteries in the
base could be low or flat; recharge or replace the
batteries.
• Verify the antenna of the LWS-BS is attached
tightly. Otherwise put it into the LWS-BS and turn it
clockwise.
• Verify you are in range of the LWS-BS; move closer
to the base if necessary.
System Power
failure
• Is the power connected
well?
• Check all connections
• If there is an AC power failure, you must re-connect
the AC adapter to turn-on the system again.