Page 12
Figure 2 - Surface Mount Hardware
Leviton recommends that cabinet mounting hardware reaches through
the drywall and attaches to the wall studs. However, properly sized struts
and suitable hardware can also be used. They must distribute the load to
the anchors without exceeding the recommended anchor limit. Using
drywall screws directly through drywall without a stud is not
recommended.
Flush Mount
Step 1B - Flush Mount Frames
All Cabinets are designed to accept a Flush Mount kit (See Table 2
)
which
is designed like a picture frame. To install, simply remove door, screw the
four pieces to the front frame of the cabinet using the provided hardware
and replace the door.
Install Steps - All Cabinets
1
Remove the screws holding the front door closed; these are located along
the top, bottom and right edges.
2
Locate the Flush Mount Hardware and place on the side of the cabinet as
shown in Figure 3.
3
Screw them in place with the provided 10-32 x
1
/
4
" self tapping screws.
The bottom left edge is not accessible for attaching a fourth mount.
4
Attach the unit to the wall using #10 or larger screws or 16-penny or
larger nails, through the
1
/
4
" diameter holes in the mounting bracket and
on the top, right, and bottom sides of the cabinet.
Attach mounting brackets to
the back of the cabinet
as shown, using the
10-32 x
1
/
4
"
self-tapping
screws provided
Top
