2. Secure the Network Camera to the supplied camera stand as the illustration
shows.
3. Secure the Network Camera to the wall/ceiling by the supplied camera
stand.
4. Feed power to the Network Camera and connect it to the Internet. For more
information, please refer to Network deployment section for details.
5. Install the “Installation Wizard“ to assign IP address to the Network Camera.
For more information, please refer to Software installation section for details.
6. Access to the Network Camera from the Internet. For more information,
please refer to Accessing the Network Camera section for details.
7. Unscrew the zoom controller to adjust the zoom factor. Upon completion,
tighten the zoom controller. Unscrew the focus controller to adjust the focus
range. Upon completion, tighten the focus controller.
8. Put the supplied silica gel into the Network Camera and tighten the lens
cover. (Please replace the silica gel with a new one if you open the lens cover
after installation.)
