Hardware Reset
There is a reset button on the inner side of the Network Camera
.
It is used to
reboot the Network Camera or restore the Network Camera to factory default
.
Sometimes rebooting the Network Camera could set the Network Camera
back to normal state
.
If the problems remain after rebooted, restore the
Network Camera to factory default and install again.
Reboot
: Press and release the reset button. The status LED will blinks two
short one long in red.
Restore
: Press the reset button continuously for over 5 seconds until the
status LED blinks two short one long in red. Note that all settings will be
restored to factory default.
Installation
Hardware installation
Follow the steps below to install the Network Camera:
1. Open the lens cover.
