Maintenance
66
AMS 300
i
Leuze electronic GmbH + Co. KG
12
Maintenance
12.1
General maintenance information
With normal use, the laser measurement system does not require any maintenance by the
operator.
Cleaning
In the event of dust build-up or if the warning message (ATT) is displayed, clean the device
with a soft cloth; use a cleaning agent (commercially available glass cleaner) if necessary.
Also check the reflector for possible soiling.
Attention!
Do not use solvents and cleaning agents containing acetone. The use of such solvents can
dull the reflector, the housing window and the display.
12.2
Repairs, servicing
Attention!
Access to or changes on the device, except where expressly described in this operating man
-
ual, is not authorized.
The device must not be opened. Failure to comply will render the guarantee void. Warranted
features cannot be guaranteed after the device has been opened.
Repairs to the device must only be carried out by the manufacturer.
Contact your Leuze distributor or service organization should repairs be required.
The addresses can be found on the inside of the cover and on the back.
Note!
When sending laser measurement systems to Leuze for repair, please provide an accurate
description of the fault.
12.3
Disassembling, packing, disposing
Repacking
For later reuse, the device is to be packed so that it is protected.
Note!
Electrical scrap is a special waste product! Observe the locally applicable regulations regard
-
ing disposal of the product.
