Lenovo ThinkSystem NE2552E, Application Manual

Page: 55 / 574

© Copyright Lenovo 2018 Chapter 1: Switch Administration
55
Configuring Strict Mode
To change the switch mode to boot strict mode, use the following command:
When strict mode is enabled, you will see the following message:
For SNMPv3 default users, see “SNMP Version 3” on page 479 .
When strict mode is disabled, the following message is displayed:
You must reboot the switch for the boot strict mode enable/disable to take effect.
Limitations
In Lenovo ENOS 8.4, consider the following limitation/restrictions if you need to
operate the switch in boot strict mode:

Power ITEs and High ‐ Availability features do not comply with NIST SP
800 ‐ 131A specification.

The NE2552E will not discover Platform agents/Common agents that are not in
strict mode.

Web browsers that do not use TLS 1.2 cannot be used.

Limited functions of the switch managing Windows will be available.
NE2552E(config)# [no] boot strict enable
Warning, security strict mode limits the cryptographic algorithms used by
secure protocols on this switch. Please see the documentation for full
details, and verify that peer devices support acceptable algorithms
before enabling this mode. The mode change will take effect after
reloading the switch and the configuration will be wiped during the
reload. System will enter security strict mode with default factory
configuration at next boot up.
Do you want SNMPV3 support old default users in strict mode (y/n)?
Warning, disabling security strict mode. The mode change will take effect
after reloading the switch.