Lenovo ThinkSystem NE2552E, Application Manual

Page: 180 / 574

180
NE2552E Application Guide for ENOS 8.4
Per-VLAN Spanning Tree Groups
PVRST mode supports a maximum of 128/256 STGs, with each STG acting as an
independent, simultaneous instance of STP.
Multiple STGs provide multiple data paths which can be used for load ‐ balancing
and redundancy. To enable load balancing between two NE2552Es using multiple
STGs, configure each path with a different VLAN and then assign each VLAN to a
separate STG. Since each STG is independent, they each send their own IEEE
802.1Q tagged Bridge Protocol Data Units (BPDUs).
Each STG behaves as a bridge group and forms a loop ‐ free topology. The default
STG 1 may contain multiple VLANs (typically until they can be assigned to
another STG). STGs 2 ‐ 128/256 may contain only one VLAN each.
Using Multiple STGs to Eliminate False Loops
Figure 13 shows a simple example of why multiple STGs are needed. In the figure,
two ports on a NE2552E are connected to two ports on an application switch. Each
of the links is configured for a different VLAN, preventing a network loop.
However, in the first network, since a single instance of Spanning Tree is running
on all the ports of the NE2552E, a physical loop is assumed to exist, and one of the
VLANs is blocked, impacting connectivity even though no actual loop exists.
Figure 13.
Using Multiple Instances of Spanning Tree Group
In the second network, the problem of improper link blocking is resolved when the
VLANs are placed into different Spanning Tree Groups (STGs). Since each STG has
its own independent instance of Spanning Tree, each STG is responsible only for
the loops within its own VLAN. This eliminates the false loop, and allows both
VLANs to forward packets between the switches at the same time.
VLAN 1
VLAN 30
Application Switch
Switch 1
False
Loop
Application Switch
Switch 2
VLAN 1
is active
STG 1
VLAN 30
is active
STG 2
x
With a single Spanning Tree,
one link becomes blocked.
Using multiple STGs,
both links may be active.