Lenovo ThinkStation 4215, Hardware Maintenance Manual, Page: 80 / 180

Diagnostic Error Code FRU/Action
170-198-XXX
Voltage Sensor(s) test aborted
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, “Using the Setup Utility
program,” on page 49.
2. Flash the system and re-test. See
“Updating (flashing) the BIOS” on page
167.
3. Go to “Undetermined problems” on
page 81.
170-199-XXX
Voltage Sensor(s) test failed, cause unknown
1. See “Undetermined problems” on page
81.
2. Flash the system and re-test. See
“Updating (flashing) the BIOS” on page
167.
3. Replace component under function test.
170-250-XXX
170-251-XXX
Voltage Sensor(s) Voltage limit error
1.
Power supply
2.
System board
170-254-XXX
Voltage Sensor(s) Voltage Regulator Module
error
1. Voltage Regulator Module (VRM)
2. Microprocessor
3. System board
175-000-XXX
Thermal Sensor(s) Test Passed
No action
175-0XX-XXX
Thermal Sensor(s) failure
1. Flash system
2. System board
175-195-XXX
Thermal Sensor(s) Test aborted by user
Information only
Restart the test, if necessary.
175-196-XXX
Thermal Sensor(s) test halt, error threshold
exceeded
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
175-197-XXX
Thermal Sensor(s) test warning
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility
program,” on page 49.
2. Re-run test.
3. Replace the component that is called out
in warning statement.
4.
Replace the component under test.
175-198-XXX
Thermal Sensor(s) test aborted
1. If a component is called out, make sure
it is connected and/or enabled .
2. Flash the system and re-test. See
“Updating (flashing) the BIOS” on page
167.
3. Go to “Undetermined problems” on
page 81.
74
Hardware Maintenance Manual