Lenovo RackSwitch G7052, Installation Manual

Page: 35 / 86

© Copyright Lenovo 2015 Chapter 3: Installing G7052 Hardware and Options
35
Installing the G7052 in a Rack
The G7052 can be rack-mounted using one of the following mounting kits:
•
For a standard 19-inch equipment rack, use the 2-post rack mounting brackets
and screws included with the switch. Installation instructions begin on
page 35 .
• For a Lenovo System x
®
or Power 4-post rack, use the Lenovo Adjustable 19”
4-Post Rail Kit. This kit must be purchased separately. Installation instructions
begin on
page 38 .
• For a Lenovo iDataPlex
®
rack, use the iDataPlex mounting kit. This kit must be
purchased separately. Installation instructions begin on page 43 .
Installing the G7052 in a Standard Equipment Rack
This section describes how to install the G7052 in a standard 19-inch equipment
rack using the mounting kit included with the switch. For information about mounting
the switch in other supported racks, see the appropriate section in this chapter.
The following parts are included in the standard mounting kit.
Attention:
The rack-mounting frame may be unable to support the weight of the
switch with only the front post mounting brackets (2-post application). If the switch
has an undesirable amount of sag, it is recommended to use a 4-post mounting kit.
Attention:
For earthquake stability, mount the switch in a 4-post rack.
Statement 26
CAUTION:
Do not place any object on top of rack-mounted devices.
Table 7. 2-post rack mount kit parts
Item number Description Quantity
1
Mounting brackets 2
2
M4 screws 8
3
M6 screws 4
4
M6 clip nuts 4
5
M6 cage nuts 4
6
M6 locking washers 4