Lenovo HR630X V2, User Manual

Page: 113 / 134

Step 2. Install the system board to the server.
Figure 80. System board installation
a. Hold the lift handle 1 and the release pin 2 at the same time to lower the system board onto
the chassis.
b. Slide the system board to the rear of the server until the system board snaps into position.
Ensure that:
• The new system board is engaged by the locating pin 3 on the chassis.
• The rear connectors on the new system board are inserted into the corresponding holes in
the rear panel.
• The release pin 2 secures the system board in place.
After you finish
1. Install any components that you have removed from the failing system board.
• “Processor and heat sink” on page 73
• “Memory modules” on page 57
• “System fans” on page 97
• “RAID super capacitor modules” on page 84
• “Riser assemblies” on page 92
• “CMOS battery” on page 31
• “OCP 3.0 Ethernet adapter” on page 67
2. Properly route and secure the cables in the server.
Chapter 4
.
Hardware replacement procedures
105