Lenovo HR630X V2, User Manual

Page: 85 / 134

• Optional devices available for your system might have specific processor requirements.
Procedure
Figure 49. Processor installation
Step 1. Slide the processor carrier into the rail frame.
Step 2. Push the rail frame down until the blue latches lock into place.
Step 3. Close the force frame.
Step 4. Tighten the screws in the installation sequence shown on the force frame.
Note: Use an ESD safe screwdriver and set the maximum torque value to 14.0 ± 0.5 inch-pounds.
After you finish
Install the heat sink. See “Install a standard heat sink” on page 77 or “Install a T-shaped heat sink” on page
79.
Install a standard heat sink
Use this information to install a standard heat sink.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Before installing the heat sink:
• If you use the existing heat sink:
1. Remove the thermal grease on the heat sink by using an alcohol cleaning pad.
2. Apply new thermal grease (TaiSol TC5288) in a quadrilateral design on the top of the processor.
Note: Do not apply too much thermal grease. Too much thermal grease can result in excess grease
coming in contact with and contaminating the processor socket.
Chapter 4
.
Hardware replacement procedures
77