Step 4. Position the riser assembly on the chassis. Align the plastic clip and two pins on the bracket with
the guide pin and two holes on the chassis and align the riser card with the riser slot on the system
board. Then, carefully press the riser assembly straight down into the slot until it is fully seated.
Figure 74. Riser assembly installation
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 110.
System fan replacement
Use this information to remove and install a system fan.
Remove a system fan
Use this information to remove a system fan. You can remove a hot-swap fan without powering off the
server, which helps you avoid significant interruption to the operation of the system.
About this task
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
.
Hardware replacement procedures
97
Summary of Contents for HR630X V2
