Lenovo 3376, Maintenance Manual

Page: 139 / 174

Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To replace the power supply assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 119.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 120.
4. Pivot the drive bay assembly upward. Then, pivot the two plastic retaining clips outward to remove
the heat sink fan duct from the failing heat sink and fan assembly.
3
4
5
6
7
8
Figure 76. Removing the heat sink fan duct
5. Disconnect the power supply assembly cables from all drives and from the 14-pin power connector and
4-pin power connector on the system board. See “Locating parts on the system board” on page 79.
Note: You might also need to release the power supply assembly cables from some cable clips or ties
that secure the cables to the chassis. Make sure that you note the cable routing before disconnecting
the cables.
Chapter 10
.
Replacing FRUs (machine types: 3377, 3386, and 3388)
135