53
buttons representing OPEN and SECURE wireless networks, along with
button for adding a network.
2.
Select the access point that has already been established and connected.
When selecting the info icon, a screen will appear which will display an
option to forget the network and IP address assigned to the thermostat
by your router, sub-net mask, router, DNS and RSSI. If the RSSI signal
strength is anywhere between -9 to -69, then the signal strength is
sufficient. If outside this range, then either relocate the router closer to the
thermostat, add a repeater, or move the smart hub. Adjusting antenna on
router and/or smart hub may resolve the issue.
Home Network . . . . . . . . . . . . . . . . . . . . . . . .
IP address
192.168.1.4
. . . . . . . . . . . . . . .
subnet mask
255.255.255.0
. . . . . . . . . . . .
router
DNS
0
4
-
I
S
S
R
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
i
forget this network
Figure 22. Verifying Signal Strength
Performance Reports
Performance reports are only available through either the consumer or dealer
web portals.
•
Homeowner access is available at
www.myiComfort.com
.
•
Dealer access is available through the Dealer Dashboard at
www.LennoxPros.com
.
More information concerning Performance Reports is available in the user
guide.
Mobile Applications
iComfort Thermostat App (Homeowner)
•
The free iComfort Thermostat app is available for use on iPhone
®
, iPad
®
and
Android™ devices.
• Control cooling/heating temperatures, fan operation, set programs and set
Away mode for multiple locations.
•
Controls individual zone settings if system is equipped with the optional
iHarmony
®
Zoning System.
• Controls PureAir
S
Air Purification System
• Controls fresh air dampers and ERV/HRV when connected to ACC1 and
ACC2 terminals.
iComfort Mobile Setup App (Installer)
•
The free iComfort Setup app allows the installer to commission and service
the system on any iPhone
®
, iPad
®
and Android™ device.
• Remotely turn the system on and off during setup.
Apple, the Apple logo, iPhone and iPad are trademarks of Apple Inc. registered in the US and
other countries.
Android is a trademark of Google Inc. Use of this trademark is subject to Google permission.
Notifications (Service and Alert Codes)
These screens provide information on active notifications and previously
cleared notifications. When selecting either a cleared or active notification a
brief description and alert code will be displayed. Notifications are categorized
by system, indoor unit (air handler or furnace), outdoor unit (air conditioner or
heat pump), zoning control (if installed) and thermostat.
Alert Code Types
To expand a specification notification to access a more detail description of the
alert code, press the down arrow to expand the description.
•
Critical
alerts are displayed on Home (user) screen under the homeowner
and installer alert buttons. Critical means that a service call is needed to get
the system running.
•
Moderate
means that the system will likely recover on its own and no
interaction is necessary. Typically, either after a specific timer period or a
specific number of instances, some moderate alerts will escalate to critical.
Moderate alerts are found only in under the installer alert button.
•
Minor
is information only and helps Lennox interpret test results and
understand complicated behaviors. Minors are not reported to homeowner
or dealer.
NOTE:
Communication System
: When communication controls are
operating in a communication system, all jumpers and links setting
on the controls are ignored. Jumpers and links setting are treated as
defaults and would only be active if the system was configured as a
non-communicating system.
