GUM AND MINT TRAY LOADING
SLIDE OUT DRAWER STYLE
The four select gum and mint dispenser is available in kit form or can be factory installed in a new machine.
Each selection will hold up to 20 packs of gum (5 stick per pack) or roll candy up to 5 inches in length. There
is a small metal tab that can be installed to allow you to dispense small rolls of anti-acid tablets or similar size
products.
All machines are prewired from the factory so you can install the gum and mint kit at a later date. The harness
for the gum and mint assembly is plugged into the motordistribution board (same board the trays are plugged
into).
LOADING INSTRUCTIONS
the tray by pushing on the tab located on the right side of the tray and pulling the tray out to the stop.
To load, push the cover toward the rear of the machine. The two wide product selections are fitted with width
adapters, installed for dispensing longer products up to 5 inches in length. Place the packs of gum or rolls
of mints on their side and stack towards the back of the gum and mint tray. Upon filling each selection, slide
the tray cover forward back into place. Then slide the tray back into the machine until latched into position.
CAROUSEL LOADING
Open the refrigerated door
section.
To
step
the carousel there is a three (3) position service switch in the upper
right hand corner of the cabinet. If you press this button the carousel will step 30 degrees, l/l 2 of turn, which
is one small compartment. If you pull the stepping switch out the carousel will run continuously. Load the tray
compartments with the desired products. Then close the refrigerated door and rotate the carousel making
sure all items are in their correct compartment according to the pricing of that tray. When you first set up the
machine it will be necessary to reset the health control by going into the service mode and then come back
out. After the health control has been reset it will not be necessary to reset it. The health control will
automatically reset). The machine will then display the message “ENJOY ONE OF OUR FINE SNACK
PRODUCTS”. In 30 minutes the cold food timer will clock out and the health control will ensure that the
temperature inside the refrigerated area is below 45 degrees. Should the temperature be above 45 degrees,
only the cold food side will be shut down and NOT the vend selections. If a cold food selection is chosen,
the display will say “Make Alternate Selection”.
Summary of Contents for Combo Series
