Lektro-Vend Combo Series, Service Manual

Page: 8 / 93

PRODUCT LOADING
Helix Tray Dispenser
There are several helix pitches available. To insure proper operation and maximum capacity, the product size
should closely match the opening between the windings of the helix so as not to be tight, but should fill most
of the opening.
The helix sizes available are listed below
CANDY HELIX
27CT
22CT
SNACK HELIX
(DUAL HELIX)
1 OCT
PRODUCT LOADING
PRODUCT THICKNESS
thin candy bar
medium candy bar
1 6” large candy bar
PRODUCT THICKNESS
1 medium chip bag or pastry
1 chip or pastry
2” large bag chip or pastry
To load a tray, lift up on the front of the tray and slide it out to the stop, then let it tilt down into the loading position.
At this point, check that each helix is in its proper position. The figure below shows the proper position.
Starting at the front of the tray, insert a product between each winding of the helix so the name of the product
is displayed forward. Be sure to place the product all the way to the bottom of the tray and tilt free end at the
top backwards. Fill from front to back and be sure not to miss any positions. Note: product must rest on tray
NOT on helix. After filling the tray, lift the front of the tray and push it back in until it hits the stop.