Lektro-Vend Combo Series, Service Manual

Page: 23 / 93

7. OF SALES MESSAGE PROGRAMMING
machine comes preset from the factory with the message “ENJOY ONE OF OUR FINE SNACK
PRODUCTS”.
If you wish to change the Point of Sales message, press the service mode button on the control board, then
press selection button The control board will display “MESSAGE”. Using the keypad overlay (provided
in the large manila envelope) and following the keypad definitions, enter the new message. Menu 1 (blue
characters is the default menu. After each key entry, from either menu, the keypad will return to menu 1.
Tc use menu 2 (red characters), SHIFT (NEXT MENU) key must be pressed prior to pressing a menu 2 key.
If you enter the wrong letter, press BACK SPACE to remove that letter from message. Put two (2) spaces
at the end of the message to prevent the message from running together. To save the message press “SHIFT”
then press “ENTER” from within menu 2.
Note: The maximum number of characters you can enter to form a message is 53 plus two spaces at the end
of the message. A space between two words is one character.
1
2
G
B H
C I
D
J
E K
F L
SPACE SHIFT
(NEXT MENU)
N T Z
5
0 U 0
6
P
1 7
W 2
8
X 3
BACK
l
ENTER
SPACE
ENJOY OUR SNACKS”. Press selection button MESSAGE” appears on display. Using the
overlay press the letter E, letter N, letter J, letter 0, press SHIFT, press
press SPACE,
press press SPACE, press SHIFT, press S, press N, press A, press C, press press Press Press
S
PACE
, press SPACE, press SHIFT, press ENTER. The message should start scrolling when you Press the
mode switch.