Lektro-Vend Combo Series, Service Manual

Page: 12 / 93

REMOVING A CAROUSEL JAM
NOTE: If the carousel drive motor ever fails and the carousel is not in a position that the tray halves can be
removed, do the following to remove the chain.
1. In the bottom of the machine is a wing nut wrench. (A long piece of metal pipe with notches
at one end located on the left side in the bottom.)
2. The wrench is used to reach the wing nut on the drive motor bracket which is located on the back
wall. (Insert the wrench under the top sprocket.)
3. Loosen the wing nut only enough to drop the chain off the sprocket so the carousel can be turned
by hand in the reverse direction to unjam the unit. Do not loosen the
enough that it
drops off. Once you have unjammed the carousel reinstall the chain, ensuring that the tray
dividers line up with the right security panel by each delivery door on the machine.
NOTE: Care must be taken to not over tighten the sprocket chain or the unit may bind up.
CHANGING DIVIDER POSITION CAROUSEL TRAY
Divider positions can only be changed while the tray half is removed from the machine.
1. Loosen the screw holding the clip in place. Then the security cover and clip. See
Figure 3.
2. Lift the rear of the divider first with a slight upward pressure. This allows the divider latch
to slip out of the tray bottom. To replace the divider reverse this sequence of steps.
3. Replace the security cover and clips as required. Slip clip under screw and tighten.
See figure 3 below.
SECURITY CLIP
SECURITY COVER
TRAY BOTTOM