Lektri-Co 1P7K, User And Installation Manual

Page: 29 / 42

1P7K user and installation manual 29
7. Load balancing sensor installation and
configuration
Before starting the installation, please read this manual thoroughly. Failure
to follow recommended procedures may malfunction, endanger life, or
violate the law. The manufacturer is not responsible for any loss or damage
in the event of incorrect installation or operation of the device
Use
The complementary load balancing module allows you to manage and
balance the load between your electrical system and EV charger so that
power consumption is kept within the limit of the main circuit breaker.
Load balancing modes:
Disabled
This mode disables any load balancing but continues to report meter
values.
Power
This is the normal mode of operation, ensuring that the circuit breaker’s set
limit is not exceeded. Any connected charger will adjust its charging power
to meet the set limit.
Hybrid
Hybrid mode allows you to use the solar panels and redirect the excess
energy to charge your car. Instead of injecting the surplus into the grid,
this mode will adjust the charging current so that all the surplus energy is
used for charging. This mode will allow the minimum charging current to
continue if no excess is available.
Green or ECO
Green (ECO) mode will only charge your car with green energy: charging
will only start and use surplus solar energy if enough surplus solar energy
is available. If the solar power output drops below the minimum charging
current, charging will stop until solar power is available again.