1P7K user and installation manual
23
dedicated circuit breaker from the junction box is on.
ELECTRICAL VEHICLE CHARGING DOES NOT START
There could be multiple reasons for charging not to start:
•
check that the connector plug is inserted properly into the electric vehicle
charging port - try to reconnect the connector plug;
•
check that the pins of the connector plug are not damaged or full of
debris (e.g. dust, dirt);
CAUTION
Always cut off the power supply of the 1P7K charger
from the dedicated MCB before cleaning the pins of the
connector plug.
•
check that the remote server authorized the start of the charging
process;
•
check that the electric vehicle is not fully charged and that there is no
error on board;
CHARGING POWER IS LOWER THAN EXPECTED
There could be multiple reasons why the charging power may be reduced and
lower than the maximum (installation) set current:
• Charging power may be limited by EV:
the EV might only be capable of
slower charging or might reduce the power at the end of a charging cycle.
• Dynamic current limiting:
when using the power managment add-on or an
when controlled by API ori a smart home, the charger will reduce the power
according to the requested current. Check connected device or restart the
charger if necessary.
• Charger may be overheating:
the power is reduced to decrease the
temperature. Might happen if the charger is installed in a sunny place, thus
exceeding the operating temperature.
THE CONNECTOR PLUG CANNOT BE DISCONNECTED FROM THE ELECTRIC VEHI-
CLE
Make sure that the charging process is finished by the electric vehicle. Check
the user guide of the electric vehicle for details about how to stop the charging
process.
GENERAL ERROR – FRONT LED IS LIT SOLID RED
Summary of Contents for 1P7K
Page 1: ...1P7K user and installation manual Documentation version v2 1 October 2022 ...
Page 40: ...1P7K user and installation manual 40 10 NOTES ...
Page 41: ......
Page 42: ......
