FlexLine, 204
Applications
9.14.3
Measuring Traverse
Access
From the
TRAVERSE START
screen select one of the following:
1.
Without known Backsight
: Starts the traverse without a known backsight. The
measurements begin to a foresight point.
2.
With known Backsight
: Starts the traverse with a known backsight.
3. With known Azimuth: Starts the traverse with a user-defined azimuth.
Without known
backsight
Start a traverse without a known backsight
• Start on a known point without an intial measurement to a known backsight.
• Stop on a known point, or make a final foresight measurement to a known
closing point.
If the coordinates of the start station are unknown, the Station Setup application can
be run before the traverse. A Helmert transformation will be performed at the end
of the traverse.
If the traverse is left open, then the calculations are based on the system azimuth.
C1, C3
Control points
C2
Check point
P1...P3
Traverse points
TP1...TP3
Topographic points
TSOX_060
C1
P1
P2
P3
C3
TP3
TP2
TP1
C2