59
iCON grade, Calibrating the System
Measure the mast
height
Measure the vertical height from the sensor mount point to the blade
edge. See figure 5.
If the machine is using a GPS the height is measured from the underside
of the threaded metal insert on the GPS antenna, if it’s using a prism the
height is measured to the centre of the prism (for a MPR122 360 MA
prism this is 5.0 cm from the bottom of threaded insert).
In 3D mode set the blade wear to 0.5m
Enter left and right blade offset (Figure 4)
Mast Height (Figure 5)
