30
iCON grade, System Installation
2.8.2
Installing the L-Bar
How to install the
L-Bar
1. Find a suitable position for the L-Bar Mounting bracket close to the
end of the blade.
2. Weld the L-Bar Mounting bracket firmly to the blade.
Warning
Before starting to weld, check that the machines battery is disconnected
and that any electronic systems are removed. (Contact your dealer, if
necessary.)
3. Insert the short end of the L-Bar into the bracket far enough so that
the longer tube end is away from the blade end and vertical. Tighten
the bolts to prevent the L-Bar from rotating in the bracket.
4. Install the sonic arm onto the L-Bar and hand tighten using the
ratchet handle assembly. Attach the Ultrasonic or Tri-Sonic sensor
onto the sonic arm by inserting the round tracer feature into the
bracket at the end of the sonic arm and tighten using the ratchet
handle assembly.
5. Install the laser receiver onto the L-Bar by loosening the mounting
clamp on the laser receiver and putting it over the L-Bar. Hand tighten
the finger screw on the mounting clamp firmly to prevent the laser
receiver from rotating or sliding on the L-Bar.
Mounting bracket for L-Bar
Mounting bracket for manual/elec-
tric mast.
