Lehigh DTM-MA, Manual

Page: 30 / 46

• Put this file in the root folder of a USB flash drive (memory stick). The file will automatically
be deleted after the installation. If you do not want this to happen, make the file read-only
(select the file, right-click, select properties, check the Read-only box).
• Pull the station out from the wall to access the USB port. See section 3.10 for instructions.
•
Plug the flash drive into the USB port on the right side of the station.
•
From the Station tab, touch ‘Station Firmware’, then ‘Update Firmware’.
• Follow the instructions on the screen.
3.6.3 Clean me
Use this button to disable the touchscreen for cleaning (section 5).
3.6.4 Relock Station
Use this button to immediately undo the temporary station unlock (rather than wait 15 minutes).
3.6.5 Focus check
Focus Check is used to control DMX output directly, when setting up and testing light fixtures. The
station's zone and DMX configuration are bypassed – all 512 channels of DMX are output. Up to 12
DMX channels can be held at 100%, use these to control power to fixtures. Additionally, one DMX
channel, the focus channel, can be set to any level. Use the focus channel to locate or test a fixture.
The focus channel overrides channels held at 100%.
Begin Focus Check from the Station tab. DMX output from Focus Check will begin immediately. To
end Focus Check, touch the Done button. Focus Check cannot be used when the station is capturing
DMX input at the DMX-IN port.
26