INSTALLATION OF THE FIRE BOX
1. With the fire place fixed on a suitable outside wall, screed the recess to the level of the hearth. This ensures
accurate fitting of the fire and flue spigot alignment with the fan unit.
2. From Inside: Draw a vertical line centrally on the back wall of the fireplace opening. Measure 310mm up from
the hearth and place a mark on the line. With a suitable drill (approx 10mm) make a hole through to outside
ensuring the drill is kept level.
From Outside: Draw a rectangle 215mm wide x 330mm high centrally above the centre of the drilled hole.
Note: To successfully install this system, the bottom edge of the wall plate must be at least 3” (75mm)
from the outside ground level.
3. Carefully lift the appliance out of the packaging taking care not to damage the ceramic components in the
separate carton.
4. Remove the magnetic trim and store to one side to prevent any damage.
5. Cut the foam sealing strip (in plastic bag supplied) to length and stick a continuous strip down the two sides
and across the top of the radiant box. When the box is placed against a flat surface the foam strip will form a
seal around the boxes flange.
6. Carefully lift the appliance into position in the fireplace opening and check that the flange of the radiant box
fits flush against the sealing face with no gaps present.
7. Remove the four screws that secure the burner tray to the box, two on the front leg and two at the rear of the
tray. Remove the burner tray and place to one side (Fig. 4).
INSTALLATION PROCEDURE
7
Fig. 5
Fig. 4
Burner tray
Blanking plate
Foam Sealing Strip
Magnetic Trim
Hole (10mm approx.)
Hole (10mm approx.)
Hearth Level
Hearth
Outside
Inside
215mm
330mm
310mm
