MS-500 Mixed Signal Oscilloscope Option
16
ISSUED: June, 2009
MS-500-OM-E Rev C
Verifying Proper MS-500 Connection to your Oscilloscope and the Device Under Test
If you are concerned that your digital signals aren’t being displayed correctly, it is a good idea to
check by viewing the digital signals one at a time with an analog channel. This can point out
errors in your connection or in your logic threshold setup.
The Complete System Connection
When your system is connected properly it looks like the following photo:
It is usually easiest to debug digital line connection or display problems by viewing the digital
information on an analog channel to confirm its presence, then working back through the previous
sequence to determine where the connection or display error is.
Digital Connections
Handle with care!
The MS-500 Digital Lead Set connectors are fragile. Pull the
connector base, not the wire. Never bend the connectors.
