LeCroy Digital Oscilloscopes, Manual

Page: 22 / 213

²
*HWWLQJ6WDUWHG
,QVWDOODWLRQ&KHFN
Before powering up, check that the local power
source corresponds to the scope’s range — any
AC power source of 90–250V, 50 or 60 Hz. (
See
the
2SHUDWRU·V0DQXDO
for Safety details.)
Use the cable provided to connect to the power source.
Then turn on the scope by pushing the POWER button at the
bottom left-hand corner of the front of the scope.
Before a display appears, the instrument will perform hardware and
software self-tests, followed by a full system calibration. The front-
panel ‘standby’ LED light, located below the right-hand corner of the
screen, will be illuminated during this sequence. The full testing
procedure will take approximately ten seconds, after which the
display will appear.
before powering up. )
,QLWLDOL]DWLRQ
To initialize the scope to its default settings and
make your screen displays similar to those shown
on the following pages:
First, press on the control panel, illustrated on the
facing page.