LeCroy Digital Oscilloscopes, Manual

Page: 145 / 213

²
0HDVXULQJ6NLOOV
The screen will then display:
Note: The test status is shown
on the first line under the grid.
The number of acquisitions that
passed the test and the total
number tested are given. In this
example, 40 of 61 acquisitions
passed the test. Shown at the
end of the same line is the pass
or failure of the current
acquisition. The lines beneath
indicate what has been tested;
some CH 1 parameters are
tested by default. These lines
can be changed by pressing
the appropriate menu button for
“CHANGE TEST
CONDITIONS” (see next step),
whereby the parameter or
mask to be tested can be
specified. Here only one line —
CH 2 against the mask
displayed as trace A — will be
defined. To stop or restart the
test, press the corresponding
menu button to select “On” or
“Off” from the “testing” menu.
67(3
7LSV
: The test is performed only on points between the two
vertical cursors. These cursors can be set by turning the upper
and lower cursor knobs for the left and right cursors,
respectively. The test is applied on all acquired points by
default.
Press the corresponding menu s for “CHANGE TEST
CONDITIONS”, then for “DELETE ALL TESTS”, and then to
select “
0DVN
” from the “Test on” menu.