lemaitrefx.com
At this time, or shortly afterwards, the ‘Heat Flash’ indicator bars on the Remote handset will
reduce from 3 bars to 2, and then 1 and finally no bars, as the heater switches off.
When settled, the ‘Heat Flash’ indicator will indicate the power being used in maintaining the
working temperature. Since proportional control is used, this will vary upon the operating
environment.
8)
The machine may now be operated fully as desired with due attention to all prevailing
safety regulations.
FLUID REPLACEMENT
Replacing fluid does not require any attention to ‘priming’ conditions. The G300 uses a
unique system of fluid pumping which allows fluid system replenishment without requiring
special settings of flow control.
‘HAZE’ FLOW CONTROL
The machine will change the characteristics of the ‘Flow Rate’ settings when ‘Haze’ mode is in
effect. This allows very short burst issues up to 5 seconds apart to be selected just by the
‘Flow Rate’ control when at its lowest ‘on’ setting. ( ‘0’ is actually no flow, which can be
useful if only a single channel 0 -10v control is available).
This decreases to every 4,3,2, and 1 seconds, after which point normal flow control com-
mences as the flow rate is increased.
This feature allows instant ‘Hazing’ to be instigated by employing a high flow setting, then
allowing replenishment of loss by means of a low output, high velocity haze issue.
AUTOMATIC and CONTINUAL FLOW CONTROL
The G300 employs an extremely high accuracy thermal monitoring system. Combining this
with Micro-Processor control and a highly stable Patented Heat Exchanger, allows a self
management system to automatically adjust the flow rate for maximum conditions at any
temperature. This means that regardless of energy availability, a continual flow setting is
automatic. If the initial flow setting is high, then this will be decreased as flow continues,
until such time as a stable situation is attained.
6
Note:
Note:
Note:
