lemaitrefx.com
1)
The G300 must only be connected to a mains supply capable of sustaining at
least 18 Amps, and be adequately Grounded. The supply should be ‘clean’ and free
of interference.
2)
The Power to the G300 should be controlled by the illuminated Mains Power
switch located on the rear panel.
3)
Shortly after switching ‘ON’, the digital display on the remote panel will
show a 50H or 60H. This is an automatic line frequency check which allows highly
accurate timing features.
4)
The Display unit will now start flashing ‘HAZE’. This is a default setting. If
Regular Haze fluid is to be used, then the machine should be allowed to continue
without interruption. If the Hi-Power G300 mode of operation is required where
fog fluid will be used, then at this time of display flashing, the button marked
‘G300 MODE’ should be kept depressed. The display will change to read G300, until
such time as this mode is recorded, and the machine continues in its start up proce-
dure. The button can then be released. For those machines equipped with a G300
MODE keyswitch please refer to key card for proper keyswitch position.
Should ‘Haze’ mode be selected when the machine has been operating in
the ‘G300’ mode, then it is possible that time will be required to allow the machine
to adjust to the ‘Haze’ characteristics.
This will be indicated by a flashing ‘C’ code in the Heat-Flash window of the
remote control.
4
Operating Procedure
