(Assembly Instructions Continued)
6. Locate and connect the Power Transfor mer.
•
Locate the Power Transfor mer secured to the rear base. Carefully cut
the ca ble tie and remove the Power Transfor mer from the rear base.
Remove the packing and unwind the cord.
•
Locate the Motor Extension Wire connector attached to the rear base
(F
I G U R E
7).
•
Align the w hite dot on the Power Transfor mer connector with the arrow
on the Motor Extension Wire connector. Push the connector s together
until they are secured with no ga p between them.
--
To reduce the risk of serious injur y:
•
Never remove upholster y cover from detacha ble war ming pad.
•
Do not use pins or other means to fasten the detacha ble war ming
pad in place.
•
Do not modify the detacha ble war ming pad connector s in any way.
The connector s are designed to disconnect easily to prevent injur y.
NOTICE:
Two detachable warming pad ports are provided for convenience.
The chair is intended for use with only one detachable warming pad. Using
more than one detachable warming pad could cause the power
transformer to fail.
7. The detacha ble war ming pad is located in the pocket of the left ar m sitting.
The detacha ble war ming pad may be connected to either the seat or back
connector.
•
The back connector is located under the center back pillow on the r ight
hand sitting side of the chair (F
I G U R E
8). Push the connector s together until
they are secured with no ga p between them. When connected to the
back, the detacha ble war ming pad may be used on your neck or
shoulder s (F
I G U R E
9).
•
The seat connector is located under the chaise legrest on the right hand sitting
side of the chair (F
IGURE
10). Push the connectors together until they are secured
with no gap between them. When connected to the seat, the detachable
warming pad may be used on your upper or lower legs (F
IGURE
11).
--
To reduce the risk of serious injur y:
•
Provide a clear path for operation of the chair, back and legrest. Place
ta bles and area r ugs at a distance to allow the legrest to fully extend
without r ubbing or interference.
8. Choose a location for the chair that is close to an electr ical outlet and
proceed to the Batter y Backup Assembly Instr uctions .
NOTICE:
To prevent damage to the connectors and cords, it is important
to unfasten all connections prior to removing the back.
9. To remove the back, unplug the Power Transfor mer and rever se the
Assembly Instr uctions steps .
(1LH) Luxur y-Lift
®
Power Recliner with Heat
Assembly Instr uctions:
(1LH) Luxur y-Lift
®
Power Recliner with Heat
Assembly Details:
F
I G U R E
9
F
I G U R E
8
F
I G U R E
7
Motor
Extension
Wire
Connector
Power
Transfor mer
Connector
F
I G U R E
10
F
I G U R E
11
Center
Back
Pillow
Back
Connector
For
Detacha ble
War ming
Pad
Seat
Connector
For
Detacha ble
War ming
Pad
Chaise
Legrest
21
20
WARNING
WARNING
