6600-NG User’s Manual
125-9110A
Page 58
usually entered by the user (units, target values, modes). The 6600-NG can store up to 10 profiles in its
non-volatile memory.
Profile number 10 is factory-installed. It is names as “Test-1” and serves only as an example. To run this
profile, press ‘
4
’ while in the Functions menu. The following will appear.
Figure 3.37 : Run Profile (enter profile number)
Enter the Profile number. In this case, enter ’10.1’ followed by ENTER. This will bring up point 1 of
profile 10. (To run profile number 1, starting at point 1, you would enter ‘1.1’. So, an entry format of ‘n.p’
instead of ‘nn.pp’ is also valid.). The screen will appear as follows.
Figure 3.38 : Run Profile (10.1 Blinking)
As shown in Figure 3.38, the following changes have been made to the Upper section of the screen:
a.
Units have been set to Pt=knots, Ps2=Dfin & Ps1=Feet
b.
Targets have been set to Pt=100.0 knots, Ps2=0.1000 Dfin and Ps1= -1000 Feet
c.
Target-Rates have been set to Pt=150.0 knots/min, Ps2=4.000 inHg/min and Ps1=2000 Feet/min
d.
Modes have been set to Control on all 3 outputs
5.7
100.0
Pt inHg
Pt
Ps2
Ps1
Control
knots/min
0.0
150.0
Dfin
Feet
0.0001
45
knots
0.1000
-1000
inHg/min
Feet/min
0.000
0
4.000
2000
Control
Control
AC
92%
Hide/Show Ps2
000
Run Profile
Running Profile :
Use keys for more points;
GO
to execute;
CANC
to exit profile
10.1
Test-1
Run Profile
Enter Profile number & point (nn.pp):
Press
CANC
to exit
