6600-NG User’s Manual
125-9110A
Page 33
Pt kpa
0.001
Qc kpa
0.001
EPR
0.001
Ps1 Target value
The Ps1 Target value can be changed only if the key# symbol
(6)
is displayed to the right of the Ps1
Target value field. Press key ‘
6
’ on the keypad and the Lower section of the display will appear as shown
in Figure 3.13 below.
Figure 3.13 : Ps1 Target value
Use the keypad to enter the desired value in the field shown. To clear an entry, press
CLR
. To accept the
entry, press
ENTER
. To exit this screen without changing the Target value, press
CANC
. If the number
of digits entered (either before or after the decimal) exceeds the maximum allowed for the current units, a
long beep will be heard.
If the entered value exceeds the programmed limits, the following message will appear.
Ps1 target exceeds limit. Press
CLR
If the Target value needs to be changed in small increments, instead of entering a value, the arrow keys
may be used to Jog the Target value up or down. If the current Ps1 Target value is 0 Feet, and the Lower
screen appears as in Figure 3.13 above, pressing the
Up-Arrow
key will make the screen appear as shown
in Figure 3.14 below.
Ps1 Target
Enter Ps1 target value: inHg
Use keys to jog target value
Press
CANC
to exit
