6600-NG User’s Manual
125-9110A
Page 54
When
GND
is pressed, the Lower section of the screen appears as below.
Figure 3.42 : Confirm GND
Pressing
GO
will activate the 6600-NG to perform the operations described above.
3.9
HOLD FUNCTION
This function needs to be used only if the user wants to “Pause” while the 6600-NG is ramping from one
target to another. This function is valid only when one or more outputs is in Control mode. When the
HOLD
key is pressed, the 6600-NG will stop ramping all outputs and try to maintain a zero-rate for Pt,
Ps2 and Ps1.
The Lower section will display the following message:
Output(s) are on “Hold”. Press
GO
to release “Hold”
In the Upper section, all the target values will be blinking. The Actual values will stop ramping towards
the targets.
Note: The target values are not altered during “HOLD”.
To release “HOLD”, press
GO
. The target values will stop blinking and the outputs will start ramping
once more towards their targets.
It is meaningless to use Hold when the outputs are already at their targets and not ramping.
3.10
OTHER FUNCTIONS
There are several other functions available on the 6600-NG that can be accessed by pressing the
FUNC
key. These are explained in the sub-sections below. The functions available are:
1.
View Limits
2.
Modify Limits
3.
Brightness (Adjust display brightness)
4.
Run Profile
5.
Load Profile
6.
Height Correction
Confirm GND
Press
GO
to achieve “Ground” or
CANC
to exit
