Lattice Semiconductor LIFCL-40-EVN, User Manual

Page: 13 / 59

CrossLink-NX Evaluation Board
User Guide
© 2019-2021 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal .
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-EB-02028-1.4 13
Table 2.1. Jumper Table
Part Description Setting
JP1 FTDI Reset Jumper Default Open (active FTDI)/Short (reset FTDI)
JP2 FTDI Oscillator Jumper Default Short (12 MHz OSC connected)/Open (12 MHz OSC
unconnected)
JP3 Raspberry Pi Connector Power
Default Open (Raspberry Pi self-power)/Short (3.3v applies
Paspberry Pi connector )
JP4 Raspberry Pi Connector Power Default Open (Raspberry Pi self-power)/Short (5.0v applies
Paspberry Pi connector )
JP6, JP7, and
JP8 VADJ Selection Jumper For FMC LPC
Carrier Connector NO Jumper -> 1.5 V (JP6, JP7, and JP8 open)
Only JP8* Short -> 1.8 V
Only JP7* Short -> 2.5 V
Only JP6* Short -> 3.3 V
J13 125 MHz / 200 MHz OSC Selection
Jumper Default 1–2 (125 MHz)/2-3 (200 MHz)
J21 ADC_REFP0 Selection Jumper Default 1–2 (V1P8_ADC_VREF)/2-3 (J26 connector Input Voltage)
J22 ADC_REFP1 Selection Jumper Default 1–2 (V1P8_ADC_VREF)/2-3 (J26 connector Input Voltage)
J24 ADC_DN0 Selection Jumper Default 1-2 (Disable), 2-3 (J26 connector)
To select POT, wire jumper: J24-1 to J25-2 and J24-2 to J25-1.
J25 ADC_DP0 Selection Jumper
J44 VCCIO0 Supply Voltage Selection
Jumper Default 1–2 (3.3 V)/2-3 (1.8 V)
J33 VCCIO6 Supply Voltage Selection
Jumper Default 1–2 (3.3 V)/2-3 (1.8 V)
J3,J4,J5,J7,J8,J9,
J23,J28,J29,J30,
J31,J32,J34,J35,
J36,J37,J38,J40,
J41,J42, and J43 Current Measurement 2 Pin Header —
*Note: Only one jumper at a time. Otherwise, damage could occur.