Laski Predator, Operating Instructions Manual

Page: 31 / 59

Predátor P 56RX
31
- Avoid contact between sharp concrete edges etc. and the rubber track.
- Fuels or synthetic oils must never come in contact with the rubber track. If this
does happen then they must immediately be cleaned.
- Avoid using rubber tracks in marine and seaside environments since saline air
or salt in general corrode adhesion between rubber and metal inner core.
Track widening
Take care when widening or narrowing the tracks. Contingent obstacles
e.g. stumps, walls etc., could cause unnecessary wear to the rubber tracks
and its mechanism and could also cause a track to come off. Also take care
that no people or obstacles may be caught between the tracks and the
machine or between the tracks and other obstacles.
Checklist before Operation
- Before the first putting into operation check up the machine for contingent
damages and completeness after its transport and storage.
- Check out tightening of bolted joints, especially of guards and completeness of
other parts.
- Check out the cutting head for its condition (attachment and wear of blades,
bolts, etc.). Check out condition of the blades. Replace them if worn or
damaged. CAUTION! The blades are fitted as left and right.
- All blades should be replaced always at the same time as a set. Pay special
attention to their fixing bolts. Replace them if worn or damaged.
- Check up hydraulic hoses for wear. Replace them if necessary or every four
years at least.
- Check up the rubber tracks for wear.
- Check up volume of service fluids available.
- Check out guards, movability of turnable parts respectively functionality of the
machine.
- It is strictly forbidden to start the machine with removed guards.
- It is strictly forbidden to do any technical changes on the machine.
- Check out the hydraulic system for condition and contingent leakage.
- Do not use petrol or similar inflammable matters as a cleaning agent.
- If any adjustment is required, do it always at standstill only.
- Observe the working area. If any person, children or animals approach while
cutting (within a 20 metre radius of the machine), then stop working
immediately.