Laski Predator, Operating Instructions Manual

Page: 12 / 59

Predátor P 56RX
12
❑ to check up functions of all controls and safety elements before putting the
machine into operation,
❑
to avoid disturbing other people with noise, exhaust gases or ejected flying
particles (at windy weather),
❑ to protect property, vehicles and people from flying debris and to use sufficient
screening accordingly,
❑
to keep traffic rules and local regulations when going or working on or nearby
public roads.
❑ Do not leave the machine unattended – pull out the ignition key.
❑
While working, wear always personal protective equipment - protecting shield
or goggles, protective gloves, working boots and working clothes properly
buttoned.
❑ Avoid wearing free parts, such as ties, scarves and shawls, belts, jewellery etc.
In case of longer hairs use always a proper head piece. Otherwise, such a person
is not allowed to operate this machine.
❑
Keep work safety symbols in proper order.
❑ Check out the stump to be cut and remove all undesirable objects. If you see
such particles in ejected chips stop working immediately.
❑
In case of any problems and faults at work do not hesitate and stop the machine
immediately. Any fault, particularly on rotary parts, may cause fatal and
dangerous situations.
❑
Observe the working area. If any person, children or animals approach while
cutting (within a 20 metre radius of the machine), then stop working
immediately.
❑ This manual describes problems and faults that may occur at work and that could
be remedied by an instructed person. In case of other problems and faults do not
hesitate and contact the manufacturer. He is always ready to help you.
❑
Do never any technical changes or any actions that are neither given in this
manual nor allowed by the manufacturer. This machine, if not correctly installed
or adjusted, may run without problems now but in the future any of important
parts could get out of order or do fatal damage.
❑ Pay regular attention to all bolted joints. Keep them properly tightened.
❑ Do not start the machine in confined or ill-ventilated spaces.
❑
Always ensure that the cutter arm is in its top position and clear of any obstacles
before trying to start the machine
❑ When having finished the work or for a break, turn off the cutting head drive
and reduce the engine speed to idling.
❑
While idling, wait for about 1 minute to let the engine and its turbo-set
cool down.