LaserBit Giga Series 4.3 page
38
10.3.3
Alignment of the heads
•
Target Side B with the crosshair built in to the
head on Side A
•
Repeat the first step with Side B!
•
Power up the heads!
•
Screw the three nuts up tight on both heads,
which are used for the horizontal fixation, but
be careful that the heads do not move out
from its position!
•
Screw the two nuts up tight on both heads,
which are used for the fixing the vertical
direction, but be careful that the heads do not move out from its position!
Meaningsofthe LEDs
Power:
The head is powered up.
RX OK:
There is enough light to start
communicate through the link.
Level LEDs:
The function of these10
green LEDs is to give visual
information about the incoming
light efficiency
Installation LED:
It signs you have the biggest
amount of incoming light
efficiency which is still not
overloads the receiver
Saturation:
Overload (Overloading can cause stop in the communication, and permanently it can
damage the receiver)
After 15mW (or higher) incoming light efficiency
