LaserBit Giga Series 4.3 page
43
Connecting the head to the ODIU, and the ODIU to the power
supply
Ensure that the cables are connected as it seen below.
For the power connection recommended to
use three-wired Ø0,75mm cables. The order
of the connection can be seen on the figure.
•
P – Phase
•
N - Neutral
The necessary power can be supported to the head by
the connector which can be seen in the figure next to this
text. Order of the cables from the head: (the four-twisted-
pair-wired cable)
•
Red - +12V
•
Black - -12V
•
Twisted green-yellow - GND
10.4.2
Fixing the heads
Your
GigaPRONTO
head can be fixed to its
stand with an Alignment Base Unit (ABU). On
the figure you can see an ABU, and a plinth of
a
GigaPRONTO
unit, and the necessary
fixing parts. The necessary nuts and washers
can be found on the legs of the head. The
steps of the fixing are:
•
First, fix the ABU to the stand using the
washers and nuts
•
Place the head to the ABU
•
Fix the bolts with the nuts, using the
washers
•
Tight up all the nuts
