LaserBit Giga Series 4.3 page
23
9 The mounting bracket
9.1 Mounting brackets for GigaPICOs
Laserbit
provides the mounting bracket and all the necessary components for
GigaPICO
units. A simple fixing technique of this bracket can be seen on the
following figure, required tools are as follows:
- drilling
machine
- 10 mm wrench
Bracket sizes:
Length:
463mm
Leg
Width:
263mm
Head
Width:
130mm
Drill size:
10mm wall drilling
Installation steps:
•
Place the bracket on the wall
•
Mark the wall with a permanent marker
•
Use your 10mm wall drill to drill all of the holes into the wall
•
Clean the holes
•
Place the wall-plugs into the holes (please note that some times you need to
use hammer to put the wall-plugs into the hole, if you have to please be
careful not to break the wall-plug
)
•
Place the bracket to the wall an line it up to the holes
•
Put the screws into the wall-plug through the hole on the leg of the bracket
(please see the figure above)
•
Tighten up the screws
Packet list for the bracket:
3pcs 8x110 screw for bracket fixing
3pcs 8x100 plastic wall-plug for bracket fixing
2pcs M6x90 bolt Head fixing
3pcs M6x25 screw Head fixing
3pcs M6 bolt head fixing
6pcs 6mm spacer bracket and head fixing
6pcs 6mm spring spacer bracket and head fixing
