6 |
P a g e
1.0
JOBSITE SETUP
1.1 LT-2D3D Setup (Purchased Pre-February, 2016)
1.
When you walk into the job site, turn on the tablet and set up the tripod while the tablet is booting.
2.
Place the laser on the tripod and make sure it is in plane with the countertops.
3.
Plug in the USB cable into the tablet after Windows has fully started.
4.
Once the USB cable is connected, press the power button on the side of the laser.
5.
After the laser shows a green LED on the side next to Power, start the program by double clicking on it on the
desktop. You should wait at least 5 seconds between turning on the laser and opening the program to allow the
laser enough time to turn on and start the Bluetooth Service.
6.
You will be prompted with a window that tells you to make sure the laser is locked before proceeding.
7.
You will see in the top bar “LT Connected”
a.
If the top bar shows “LT Disconnected”
i.
Exit the program.
ii.
Unplug the USB cable and plug it back in.
iii.
Make sure the laser is on indicated by the green light on the side of the laser next to Power.
iv.
Start the program by double clicking on program on the desktop.
v.
If it is still not connected, check for any pending Windows Updates that need to be installed.
8.
After connected, press Laser On or Start New Line and you can begin templating.
1.2
LT-2D3D
Jobsite Setup (Purchased Post-February, 2016, marked R4.1 on the bottom
label)
1.
When you walk into the job site, turn on the tablet and set up the tripod while the tablet is booting.
2.
Place the laser on the tripod.
3.
Plug in the USB cable into the tablet after Windows has fully started.
4.
Once the USB cable is connected, press the power button on the side of the laser.
5.
After the laser shows a green LED on the side below Power, start the program by double clicking on it on the
desktop. You should wait at least 5 seconds between turning on the laser and opening the program to allow the
laser enough time to turn on and start the Bluetooth Service.
6.
You will be prompted with a window that tells you to make sure the laser is locked before proceeding.
7.
You will see in the top bar “LT Connected”
a.
If the top bar shows “LT Disconnected”
i.
Exit the program.
ii.
Unplug the USB cable and plug it back in.
iii.
Make sure the laser is on indicated by the green light on the side of the laser below Power.
iv.
Start the program by double clicking on program on the desktop.
v.
If it is still not connected, check for any pending Windows Updates that need to be installed.
8.
Set the plane you are going to measure by capture three points.
a.
You will be prompted to set a plane before capturing any points with the laser. If you are not going to
template immediately, you can ignore the following steps and use other functions.
b.
Points should be at least 12” apart and should not be in a straight line.
c.
Clicking the “Show Example” button in the software will bring up an image showing where to position
the three points. The points only need to generally be in a left, right, back/top orientation to one
another
9.
After connected, press Laser On or Start New Line and you can begin templating.
