8: Devices
SLC™ Console Manager User Guide
86
IP Settings
Data Settings
Telnet In
Enables access to this port through Telnet. Disabled by default.
Port:
Automatically assigned Telnet, SSH, and TCP port numbers. You can
override the value.
Timeout:
To cause an idle Telnet, SSH or TCP connection to disconnect after a
specified number of seconds, select the checkbox and enter a value from 1 to
1800 seconds. The default is 600 seconds.
Authenticate:
If selected, the SLC requires user authentication before granting
access to the port.
Authenticate
is selected by default for
Telnet in
and
SSH
in,
but not for
TCP in
.
SSH In
Enables access to this port through SSH. Disabled by default.
Port:
Automatically assigned Telnet, SSH, and TCP port numbers. You can
override the value.
Timeout:
To cause an idle Telnet, SSH or TCP connection to disconnect after a
specified number of seconds, select the checkbox and enter a value from 1 to
1800 seconds. The default is 600 seconds.
Authenticate:
If selected, the SLC requires user authentication before granting
access to the port.
Authenticate
is selected by default for
Telnet in
and
SSH
in,
but not for
TCP in
.
TCP in
Enables access to this port through a raw TCP connection. Disabled by default.
Port:
Automatically assigned Telnet, SSH, and TCP port numbers. You can
override the value.
Timeout:
To cause an idle Telnet, SSH or TCP connection to disconnect after a
specified number of seconds, select the checkbox and enter a value from 1 to
1800 seconds. The default is 600 seconds
Authenticate:
If selected, the SLC requires user authentication before granting
access to the port.
Authenticate
is selected by default for
Telnet in
and
SSH
in,
but not for
TCP in
.
Note:
When using raw TCP connections to transmit binary data, or where the
break command (escape sequence) is not required, set the Break Sequence of
the respective device port to null (clear it).
IP Address
Enables an IP address used for this device port so a user can Telnet, SSH, or
establish a raw TCP connection to this address and connect directly to the device
port.
For Telnet and SSH, the default TCP port numbers (22 and 23, respectively) are
used to connect to the device port. For raw TCP, the TCP port number defined for
TCP In
to the device port is used.
Web SSH/Telnet
Columns
Specifies the number of columns in the Web SSH/Telnet applet when this device
port is accessed via the applet.
Web SSH/Telnet
Rows
Specified the number of rows in the Web SSH/Telnet applet when this device port
is accessed via the applet.
Summary of Contents for SLC8
Page 49: ...6 Basic Parameters SLC Console Manager User Guide 49 Figure 6 1 Network Web Page...
Page 84: ...8 Devices SLC Console Manager User Guide 84 Figure 8 3 Device Ports Settings Page...
Page 121: ...9 PC Cards SLC Console Manager User Guide 121 Figure 9 3 PC Card Modem ISDN Page...
Page 135: ...11 Connections SLC Console Manager User Guide 135 Figure 11 5 Console Server...
