12: User Authentication
SLC™ Console Manager User Guide
177
2.
Enter the following:
3.
In the
User Rights
section, select the user
Group
to which NIS users will belong:
Enable NIS
Displays selected if you enabled this method on the Authentication Methods page.
If you want to set up this authentication method but not enable it immediately, clear
the checkbox.
Note:
You can enable NIS here or on the first User Authentication page. If you
enable NIS here, it automatically displays at the end of the order of precedence on
the User Authentication page.
NIS Domain
The NIS domain of the SLC console manager must be the same as the NIS domain
of the NIS server.
Broadcast for NIS
Server
If selected, the SLC unit sends a broadcast datagram to find the NIS Server on the
local network.
NIS Master Server
(required)
The IP address or host name of the master server.
NIS Slave Servers
#1 -5
The IP addresses or host names of up to five slave servers.
Custom Menu
If custom menus have been created, you can assign a default custom menu to NIS
users.
Escape Sequence
A single character or a two-character sequence that causes the SLC console
manager to leave direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is
Esc+A
(escape key, then uppercase "A" performed quickly
but not simultaneously). You would specify this value as
\
x1bA
, which is
hexadecimal (
\
x
) character 27 (
1B
) followed by an
A
.
This setting allows the user to terminate the connect direct command on the
command line interface when the endpoint of the command is deviceport, tcp, or
udp.
Break
Sequence
A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is
Esc+B
(escape key,
then uppercase “B” performed quickly but not simultaneously). You would specify
this value as
\
x1bB
, which is hexadecimal (
\
x
) character 27 (
1B
) followed by a
B
.
Enable for Dial-back
Select to grant a user
. Users with dial-back access can
dial into the SLC unit and enter their login and password. Once the SLC console
manager authenticates them, the modem hangs up and dials them back. Disabled
by default.
Dial-back Number
The phone number the modem dials back on depends on this setting for the device
port. The user is either dialed back on a fixed number, or on a number that is
associated with the user’s login (specified here).
Data Ports
The ports users are able to monitor and interact with using the connect direct
command.
Listen Ports
The ports users are able to monitor using the connect listen command.
Clear Port Buffers
The ports whose port buffer users may clear using the set locallog clear command.
Group
Select the group to which the NIS users will belong:
Default Users:
This group has only the most basic rights. You can specify
additional rights for the individual user .
Power Users:
This group has the same rights as Default Users plus
Networking
,
Date/Time
,
Reboot & Shutdown
, and
Diagnostics & Reports
.
Administrators:
This group has all possible rights.
