Section 2: Adjustments
OFM3678, OFM3690 & OFM3698 Offset Flail Mowers 333-149M
6/11/21
31
Adjust Park Stands
Figure 2-3
Adjust Park Stands
Refer to Figure 2-3:
The implement is equipped with two adjustable park
stands (#3) to ensure that the implement will stand
securely on the ground while unhooked from the tractor.
Always raise park stands fully up soon after hooking-up
the implement and before moving with the implement
attached to a tractor.
Adjust Park Stands as Follows:
1. Remove hairpin cotter (#1).
2. Remove bent pin (#2).
3. Move park stand (#3) to the required position and
reinsert bent pin (#2) and hairpin cotter (#1).
4. Repeat steps 1-3 on the opposite side.
2
1
3
74982
IMPORTANT:
The park stands (#3) should always
be in the raised position before traveling with the
implement attached to the tractor.
Adjust Lateral Position
Figure 2-3
Adjust Lateral Position
Refer to Figure 2-3:
WARNING
!
To prevent serious injury or death:
Adjusting the lateral position must be carried out with the
implement raised off the ground to avoid damaging the
implement.
1. Stop forward travel with the tractor, place
transmission in park or in neutral and set the park
brake, reduce throttle speed to an idle, disengage
power take-off, and raise the mower off the ground.
2. Extend the lateral cylinder to adjust the mower to the
right (A) or retract the lateral cylinder to adjust the
mower to the left (B).
3. Once adjusted to the desired position, lower mower
to the cutting height.
4. With engine speed at idle, engage PTO. Increase
engine throttle to 540 power take-off speed.
5. Place transmission in appropriate gear range and
begin traveling forward.
B
A
74983
